The Table Mounted Suction Device can be mounted into a worktable for use or it can be used while held in the hand.  Inexpensive and easy to use, it's designed for use with high and low vacuum sources.  These suction devices suck air downward through the suction platen.  Made of aluminum.

The Table Mounted Suction Device is available in two sizes. 

The Large is 3.5 inches (9 cm) square.  The square top of the device is 3/8 inch (1 cm) thick.  The cylindrical air intake at the bottom is 2 inches (5 cm) outside diameter. 

The Small is 3 inches (7.5 cm) square, with a 2-12" inch (6.5 cm) round opening.  The cylindrical air intake at the bottom is 2 inches (5 cm) outside diameter.

Each device comes with an adapter to connect to the desired vacuum source. State what vacuum source is being used in the notes to ensure the correct adapter is included with the device.  Standard vacuum sources are considered to be the , or the MSC Vacuum Control Console.  Vacuum sources are sold separately.  Non-standard vacuum sources may require an additional charge for an adapter.

Also available for this device is the Suction Worktable.  The suction device is able to alternate being installed between two locations; along the short edge or along the long edge of the table.  The location not in use is covered with a lid for a completely flat worktable surface.

Table measures 4 x 5 feet (122 x 153 cm) and is the same sturdy construction style as an MSC Painting Lining Table.  Each table is made of a steel table frame powder coated black with a high density polyethylene table surface. 

Call to order Suction Worktable.  Custom sizes available; call to inquire.